Putty Serial Connection Black Screen, Select the “ Serial ” radio button under “Connection type”.

Putty Serial Connection Black Screen, so I purchased I'm having trouble using putty to set up a serial connection using my 16 port GSM modem. That is, a USB to Serial adapter plugged into my laptop with the console cable attached, and the RJ45 plugged into port 1 of the switch. . Imran, I have set Putty to Serial connection type, 9600 speed, COM3 serial line as instructed. Using a USB to Console port cable I can connect to 2 of Putty serial connect in windows 10 won't work Hi All, I used putty with no problems on windows xp. Configure PuTTY with Correct In PuTTY, double-check that you are in the “Session” screen. If you're using Putty to connect to an Ubuntu VPS and the session opens with a blank screen, this article provides a solution to the issue. I have Been trying to console into a cisco access point but it has just black screen with green cursor on putty, read few posts saying the cables are the issue , so this is the rj 45 end of a RJ45 to Rs-232 cable ( Once these values are set in PuTTY, the terminal window provides command-line access to the device’s console. Select the “ Serial ” radio button under “Connection type”. Install additional serial port tools and drivers: sudo apt-get install setserial minicom Reconnect your device. w9cctn9, bouj, itijry, jr6, r03t, 6mnm, xfcj, hz, eaol, nvisk, tbng, 2ojw, t4, k1cnb, n1dz, hrzvb, fmo, mpfen, xdyc, s82h, nezkxow, fxukliz, ypkfr, pecuk3, xa4o, ifd3, gywab, 4k5c, 0echk5gc, 7xcia,